Colorise RGB

COLORISE RGB

Product specification :

Colorise

Applications :

Dynamic colour change of recesses, coffers and 3D architecture

Description

The colorise system aims to address the requirements of contractors and architects for high quality, flexible, colour changing cold cathode lighting. It provides a means of obtaining around 10 pre-defined set colours from only 3 lamps. The system is designed specifically for colour changing requirements and exceptionally smooth transitions can be attained over a wide range of times. These transitions can be set up so that the lighting can fade smoothly to a colour at the push of a button.

Alternatively, the system has tremendous capabilities for very flexible automatic colour-changing output. An endlessly changing wash of colour is possible, providing a range of atmospheres for the environment in which it is installed, from a stimulating fast colour fading sequence through to a more relaxing, slow fade from one shade to another.

On this system like Colorise lighting can be integrated with other quality dimming products (such as I-Light, Lutron, Dimtek and Polaron), to control scenes and settings.

Technical Data

Please note that all dimensions are
subject to a tolerance of +/-2mm

Triple Run

Minimum : H = 60mm, W = 120mm
Typical : H = 60mm, W = 150mm

NB For curved runs allow typical dimensions.

NB This product is designed for indirect lighting applications only and is not suitable for surface mounting. For further assistance contact sales.

Features

10 colour scenes
Ultra smooth fading between colours using either 1-10 volt dimmable or DMX control signals
High power factor maintained across dimming range
Long life - 45,000 hours
Low energy - 150 watt per module
Curved or straight run
Controlled by external system (see ballast specification sheet for further information)
No fireman's switch required

Gear Mounting Position

Integral

Benefits

Covelite offers the following additional benefits :

Easy to specify

Colorise gives the designer known parameters to work with in terms of lighting performance, dimming, dimensions and power consumption. It is as easy to specify as any standard lighting product.

Easy to Install

This plug and socket arrangement minimises installation time. Loop in and out mains connections using Weiland GST18 range. Loop in and out DMX and 1-10 connections using RJ45 connections and jackplugs.

COLORISE RGB EXTERIOR

Product Specification :

Colorise Exterior

Applications :

Dynamic colour change of building façades and external details

Description

The Colorise system provides a means of creating around 10 pre-defined set colours by dimming three RGB cold cathode tubes. An endlessly changing wash of colour is possible, providing a range of atmospheres for the environment in which it is installed, from a stimulating fast colour fading sequence through to a more relaxing, slow fade from one shade to another.

This system has now been used extensively throughout the UK for interior colour changing applications, but now through the incorporation of an IP rated housing, Colorise is available for both inferior and exterior application.

On this system the Colorise lighting can be integrated with other quality dimming products (such as I-light, Lutron, Dimtek and Polaron), to control scenes and settings.

Technical Data

Colorise Exterior Housing

Features

System rated to IP65
10 colour scenes
Ultra smooth fading between colours using either 1-10 volt dimmable or DMX control signals
Fantastic colour change application to create visually stunning effects
High power factor maintained across dimming range
Long life - 45,000 hours
Low energy - 150 watt per module
Controlled by external system (see ballast specification sheet for further information)
No fireman's switch required