Recessed Square adjustable downlight with one piece die cast flat front plate for trimless installation.
Easy to install with separate plaster-in installation kit, adjustable cartridge and flat front plate.
Components installed with ball-catches.
Hot aiming, allows focusing while the lamp is on and installed
45° tilt, 350° rotation.
Keyed installation of the adjustable cartridge ensures correct alignment after maintenance.
Luminaire is standard with a clear safety glass.
IP44 as standard.
White standard finish. Black available to order

Overall dimension 112 x 112mm
Ceiling cut out 102 x 102mm
Maximum height 130mm

Allow minimum 25mm above the luminaire for air gap.
Luminaire can accept an additional 2 accessories. To be specified separately.
Specify lamp wattage and beam angle separately.
Remote electronic ballast to be specified separately.

Recessed Square adjustable downlight with one piece die cast flat front plate for trimless installation.
Easy to install with separate plaster-in installation kit, adjustable cartridge and flat front plate.
Components installed with ball-catches.
Hot aiming, allows focusing while the lamp is on and installed
45° tilt, 350° rotation.
Keyed installation of the adjustable cartridge ensures correct alignment after maintenance.
Luminaire is standard with a clear safety glass.
IP44 as standard.
White standard finish. Black available to order

Overall dimension 112 x 112mm
Ceiling cut out 102 x 102mm
Maximum height 115mm
Allow minimum 25mm above the luminaire for air gap.

Luminaire can accept an additional 2 accessories. To be specified separately.
Specify lamp wattage and beam angle separately.
Remote electronic transformer to be specified separately.